In some cases, this application may start automatically. After the Windows installation completes, install the Boot Support Software by executing the setup application in the BootCamp folder on the flash drive. Replace BootCamp.msi file in the BootCamp/Drivers/Apple folder on the flash drive with the new file. Method 1: Replace the existing BootCamp.msi file. Here a assume you have already used the Boot Camp Assistant on the iMac (21.5-inch, Mid 2011) to download the Windows Support Software to a flash drive. I tried both and decided I preferred Method 2. This is the Windows installer for Boot Camp Version 6.0 (Build 6136).īelow are two methods for solving the problem. Use to Finder application to locate the BootCamp.msi file in the BootCamp/Drivers/Apple folder of the device labeled Boot Camp.Double click on the WindowsSupport.dmg file in the Finder application to mount the disk image.This will save the WindowsSupport.dmg file to the /Library/Application Support/BootCamp folder. Note: If this link is broken, then post a comment and I will try to update the link.ĭouble click on the BootCampESD.pkg file in the Finder application to start the "BootCampESD Installer". The Windows Support Software for the iMac (21.5-inch, Late 2013) can be downloaded by following the steps given below.Ĭlick on this link to download the BootCampESD.pkg file directly from Apple. This method was derived from Chris F Carroll's answer to the question: How to download Bootcamp drivers without Bootcamp assistant? The nice thing about this answer is the Window Support Software is downloaded directly from Apple without the use of any third part tools. Since not everyone reading this will have a newer model Mac, I have provided a alternate method for retrieving this file. I did this by downloading the Windows Support Software on a iMac (21.5-inch, Late 2013). I found a solution which involves using a newer version of the BootCamp.msi file. Also, after installing the Window Support Software, the Apple Software Update application provided a download of a "Boot Camp Update Version 6.1.9". Note: I have tested the Windows 10 November 2019 Update (1909) Edition and so far this problem has not occurred. After some trial and error experiments, I determined the offending file in Windows Support Software is named BootCamp/Drivers/Apple/BootCamp.msi. How can I avoid getting this error message?Īfter some investigation, I found the error occurs after installing the Windows Support Software. I also tried a clean install of Windows 10 and this made no difference. Note: The Windows Support Software download by using the Boot Camp Assistant can vary depending on the Mac model.īelow is some information about my configuration. I installed Windows 10 to legacy BIOS boot. I confirmed the files are the same as the files that can be downloaded from the Apple website Boot Camp Support Software. The Windows Support Software was downloaded by using the BootCamp Assistant. Afterwards, the Mac would get the following "Blue Screen of Death" error message. The Windows Update (1903) Edition ISO file was downloaded from the official Microsoft website. I did an upgrade on my iMac (21.5-inch, Mid 2011) from a previous version of Windows 10 to the current version. UPDATE: I have tested the Windows 10 November 2019 Update (1909) Edition and so far this problem has not occurred.
0 Comments
Leave a Reply. |